- Úvod
- VW Brouk Typ 1 (1938 » 03)
- Motory & díly (Engines & parts)
- Sahary & krycí plechy (Fans & cover plates)
- Izolace singl předehřevu/potrubí sání - Typ 1 motor (1963 »)
Izolace singl předehřevu/potrubí sání - Typ 1 motor (1963 »)
- Kompletní specifikace
- Komentáře 0
- Související zboží11
Izolace singl předehřevu/potrubí sání - Typ 1 motor (1963 »)Skladem 8 ks272 Kč/ ks225 Kč bez DPH
Izolace pro singl předehřev kit.
Topné trubky (předehřev) jsou součástí sání motoru. Při nedostatečném přetěsnění nad výfukem, dochází k úniku horkého vzduchu a motor se nedostatečně chladí. Izolátory patří do krycích plíšků u předehřevu viz. související zboží.
Manifold heat riser insulation kit.
A heating pipe as insulation parts for the case of a air-cooled engine, it is important that the space under the engine as well as possible has been completed. If the heat from the exhaust of the engine compartment is sucked into the engine cooled by hot air, that we should try to limit as much as possible. If the cooling provision does not seal properly warm air has free access. The carburetor heating pipes which are connected to the outlet are partially enclosed with the rear panel and the connection between the cylinder plating and rear air tight to get down both left and right small sheet metal parts. In order to ensure that the heat of the heating pipes for not directly attached to the sheet metal cooling is issued, these isolated prepared. In both the back panel as small pieces of sheet metal around the pipe insulation parts are pushed. These insulators are in most cars no longer present or in a state of decomposition. The installation of new insulation parts is the only good solution is to set supplied for both the left and right tube. suitable only for engines with single manifold.
T.1 engines r.v. 1/63 » single hotspot















